 Quasi
Member
Joined: 06/Jan/2005
Member: 317
Posts: 43
|
Quote: On 18/Feb/2005 at 6:17:42 PM Paul wrote
Unless it is a freeform piece how do you make sure every piece fits good?
And how you make sure where they go if it is a large panel?
You do the fitting while cutting/grinding, before foiling.
Lots of the pieces are obvious where they go, so you don't have to keep them on the pattern. Only a few need to stay in place or you don't know which way is up.
Or if doing a lot of one or two suncatchers (a dozen valentines to give to your friends) the pieces are all pretty much interchangeable.
I play with lots of stock bevels, too. Sometimes I foil a bunch without knowing yet what I'm going to do with them.
Quasi
|
